CMM Programmer - Erie, PA,

JOB TITLE: · CMM Programmer · CLASS: · A · DEPARTMENT/DIVISION: · Modern Machining Division · REPORTS TO: · Supervisor · EEO CATEGORY: · Operatives · CLASSIFICATION: Hourly Non-Exempt (paid overtime) ·   · GENERAL: ·  Responsible for inspecting in process and finished parts to i ...

Job description

JOB TITLE:

CMM Programmer

CLASS:

A

DEPARTMENT/DIVISION:

Modern Machining Division

REPORTS TO:

Supervisor

EEO CATEGORY:

Operatives

CLASSIFICATION: Hourly Non-Exempt (paid overtime)
 

GENERAL:

 Responsible for inspecting in process and finished parts to insure that customer requirements are met.
 

MINIMUM QUALIFICATIONS (Knowledge, Skills, Abilities):

Must have high school diploma or equivalent and three years minimum experience in performing dimensional inspections.Minimum 2 years CMM programming on prismatic machined component parts.Must demonstrate proficient performance of Class B Inspector essential duties.Must be proficient in current computer software.
 

ESSENTIAL DUTIES:

1. Interpret drawings, control plans, process instructions and work instructions to determine sample quantities and features to be inspected for lots of parts.
2. Program the CMM in support of new job launches and ongoing production, and train others as needed to do so.
3. Use micrometers, calipers, visual inspection, and other gages as required to complete planned inspections.
4. Identify and report conditions that do not meet requirements, and approve acceptable parts for shipment or further processing.
5. Transfer rejected parts to staging area and log data into the ERP system.
6. Verify implementation of appropriate correct action for quality issues.
7. Maintain clean work areas and orderly storage of fixtures, gages and special inspection equipment.
8. Wear personal protective equipment and follow safety instructions as required.
9. Perform other duties as assigned.
10. Must have experiance 

 

PHYSICAL REQUIREMENTS:

• Must be able to lift parts and other items from floor to waist on a frequent basis, while protecting lifted items from damage.  Parts weigh 50 lbs. on an occasional basis, 35 lbs. on a frequent basis.
• Must be able to stand for several consecutive hours without rest, with frequent bending and reaching.
• Must be able to tolerate a hot work environment seasonally, when summer outdoor temperatures combine with residual heat from machines.
• Must be able to walk within and between areas frequently and climb stairs occasionally.

 

MENTAL REQUIREMENTS:

• Must be able to understand and carry out written and verbal instructions.
• Must be able to comprehend and comply with detailed gage calibration work instructions and practices
• Must be able to retain instructions sufficient to perform complex tasks successfully and with very minimal supervision.
• Must be able to read and understand drawings and precision measuring instruments.
• Must be able to comprehend and comply with requirements of the Quality Systems Manual as instructed.