MAINTENANCE MECHANIC LEADER with Security Clearance - Kings Bay Base, GA, United States - Department of Defense

Description

Duties

• You will be able to perform work, without close supervision, in at least two or more of the following trade practices: electrical, air-conditioning, plumbing, pipefitting, carpentry, painting, and insulation.
• You will ensure workers under your leadership have the necessary plans, procedures, blueprints, instructions, tools, etc

to perform their work operations.

• You will remove electrical fixtures and controls; make repairs; install new outlets, relays, switches, and light fixtures; test circuits; measure, cut, and bend wire and conduit to specified lengths and angles inside radiological controlled areas.
• You will operate and maintain Heating Ventilation and Air Conditioning systems and ductwork/vent inside radiological controlled areas.
• You will plan and lay out the installation, modification, and repair of various new and existing piping systems and equipment.
• You will produce requested carpentry and woodworking products to support shipyard maintenance work.
• You will take appropriate action to prevent and/or overcome bottlenecks, equipment and power breakdowns, assure that proper types and amounts of equipment are at the job site without tying up needed and expensive equipment unnecessarily

Requirements Conditions of Employment

• Must be a US Citizen.
• Must be determined suitable for federal employment.
• Must participate in the direct deposit pay program.
• New employees to the Department of the Navy will be required to successfully pass the E-Verify employment verification check

To learn more about E-Verify, including your rights and responsibilities, visit e-• Within the Department of Defense (DoD), the appointment of retired military members within 180 days immediately following retirement date to a civilian position is subject to the provisions of 5 United States Code 3326.

• Males born after must be registered for Selective Service.
• This is a bargaining unit position.
• You will be required to obtain and maintain an interim and/or final security clearance prior to entrance on duty

Failure to obtain and maintain the required level of clearance may result in the withdrawal of a job offer or removal.

• This position may require travel from normal duty station to CONUS and OCONUS and may include remote or isolated sites

You must be able to travel on military and commercial aircraft for extended periods of time.

• Work is performed in areas where potentially harmful physical and chemical agents are present (e.g

fumes, dust, heat, ionizing and non-ionizing radiation and chemicals)
You will be required to participate in medical surveillance programs.

• You will be required to wear personal protective equipment such as helmets, gloves, coveralls, glasses, goggles, respirators and safety shoes continuously for the duration of the work shift

Qualifications Although a specific length of time and experience is not required for most trade and labor occupations, you must show through experience and training that you possess the quality level of knowledge and skill necessary to perform the duties of the position at the level for which you are applying
Qualification requirements emphasis is on quality of experience, not necessarily the length of time
Your qualifications will be evaluated on the basis of your level of knowledge, skills, abilities and/or competencies in the job elements and screen out listed below
This job has a screen-out element which will be used to determine minimum eligibility for this job
Applicants who do not receive a minimum of two points on the screen-out element(s) will be found ineligible
The Screen-out Element for this position is: ABILITY TO LEAD OR SUPERVISE:

• Experience working in at least two of the following trade occupations: electrical, plumbing,
• HVAC, pipefitting, carpentry, painting, and/or insulation.
• Experience installing and operating electrical fixtures, wiring, and controls and reading and following wiring diagrams.
• Experience constructing, operating, and servicing a variety of ventilation systems, and possibly power sources, and cooling units.
• Experience installing and operating various supply, disposal, and utility systems and equipment, such as water and gas systems, fire sprinkler equipment, and water closets.
• Experience planning and laying out the installation, modification, and repair of various new and existing piping systems and equipment.
• Experience operating general and precision carpentry and woodworking equipment to produce the requested finished product.
• Experience matching, tinting, toning, and blending coating materials and agents.
• Experience applying mechanical theory, pneumatic, and hydraulic principles to repair electromechanical devices.
• Experience applying principles and theories of the refrigeration cycle, temperature measurement, and refrigerant properties.
• Experience working with various high-pressure piping systems and equipment.
• Experience interpreting complex instructions, sketches, blueprints, and building codes.
• Experience reading and applying directions to various materials, solvents, and pre-coating agents

Applicants must meet the requirements of the Office of Personnel Management (OPM) Job Qualification Handbook for Trades and Labor Occupations
Additional qualification information can be found at: Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., professional, philanthropic, religious, spiritual, community, student, social)
Volunteer work helps build critical competencies, knowledge, and skills and can provide valuable training and experience that translates directly to paid employment
Additional information This position is covered by the Department of Defense Priority Placement Program
Additional vacancies may be filled by this announcement
A tentative offer of employment will be rescinded if the selectee fails to meet the pre-employment requirements, including failure to report to any of the scheduled appointments

Federal annuitant information:
The selection of an annuitant is subject to the Department of Defense and Department of the Navy policy on the employment of annuitants
Policy information may be found at: PPP applicants will be placed at the FPL, if determined Well Qualified (WQ)
To receive priority consideration, the FPL must be the same grade level or equivalent of the retained grade or the grade held immediately prior to separation

ICTAP Applicants:
To be considered well-qualified and exercise selection priority as an ICTAP candidate, displaced Federal employees must satisfy all qualification requirements for the position and receive a rating in the highly qualified category (score 85) or higher
ICTAP candidates must provide copies of all of the following documentation at the time of application: 1) agency notice; 2) most recent performance appraisal; and 3) most recent SF-50 or notification of personnel action that includes position, grade level, and duty location
Applicants who do not provide this documentation will not receive consideration as an ICTAP candidate
For more information about ICTAP eligibility please review the following link: Military Spouse Preference applicants will be placed at the highest grade for which they have applied and are determined Best Qualified (BQ)

A BQ military spouse possesses knowledge, skills, abilities, and competencies comparable to others who meet the competitive referral criteria for the specific position.

• Benefits Help A career with the U.S

government provides employees with a comprehensive benefits package
As a federal employee, you and your family will have access to a range of benefits that are designed to make your federal career very rewarding
Opens in a new window Learn more about federal benefits
Review our benefits Eligibility for benefits depends on the type of position you hold and whether your position is full-time, part-time or intermittent
Contact the hiring agency for more information on the specific benefits offered
How You Will Be Evaluated You will be evaluated for this job based on how well you meet the qualifications above
In order to qualify for this position, your resume must provide sufficient experience and/or education, knowledge, skills, and abilities, to perform the duties of the specific position for which you are being considered
Your resume is the key means we have for evaluating your skills, knowledge, and abilities, as they relate to this position
Therefore, we encourage you to be clear and specific when describing your experience
When the application process is complete, we will review your resume to ensure you meet the hiring eligibility and qualification requirements listed in this announcement
You will be rated based on the information provided in your resume and responses to the Occupational Questionnaire, along with your supporting documentation to determine your ability to demonstrate the following job elements:

• ABILITY TO INTERPRET INSTRUCTIONS AND SPECIFICATIONS, INCLUDING BLUEPRINT READING
• ABILITY TO LEAD OR SUPERVISE
• ABILITY TO MEET DEADLINE DATES UNDER PRESSURE
• ABILITY TO PLAN AND ORGANIZE THE WORK
• KNOWLEDGE OF EQUIPMENT ASSEMBLY, INSTALLATION, REPAIR, ETC.
• KNOWLEDGE OF MATERIALS You should list any relevant performance appraisals and incentive awards in your resume as that information may be taken into consideration during the selection process

If selected, you may be required to provide supporting documentation
If after reviewing your resume and supporting documentation, a determination is made that you inflated your qualifications and