electrical assembler - Glenwillow, United States - GED Integrated Solutions

Description

• Lay out, plan and perform a wide variety of wiring and shop floor assembly installations consisting of but not limited to mechanical fastening of electronic/electrical components to electrical panels and electrical enclosures.
• Working from bill of material (B.O.M.) and shop floor routing, obtain parts and components necessary for assigned tasks. Check for apparent defects, damage to all components prior to installation/assembly.
• Work from electrical drawings, schematics, wiring diagrams, written, verbal, and own knowledge for determining location and placement of electrical assemblies, conduit, fittings motors, controls and components.
• Cut, route wires to various circuits. Check for continuity, proper markings and circuit integrity. Make preliminary connections and applicable wire harness assemblies.
• Verify work performed by making static and/or simulated operational test to determine proper component or sequential circuit performance to meet machine operational requirements.
• Use common assembly, hand and power tools, drills, conduit benders, pipe threading equipment and measuring devices such as volt meters, continuity testers and test bench equipment as required.
• Perform inventory control procedures with regards to cycle counting, verification of on hand balances and report part discrepancies, B.O.M. and routing errors.
• Report time, production or other required information on proper forms. Detect and report faulty equipment, material, or other unusual conditions to proper supervision.
• Observe all prescribed safety rules and regulations.
• Maintain work areas and equipment used in a neat and orderly manner.
• All other duties as assigned.

• Two year technical degree in Electronic/Electrical Technologies preferred.

• Working knowledge of basic measuring instruments such as volt/ohmmeter, ammeter, oscilloscope, and electronic test bench instruments.
• Working knowledge of PLC based programmers, as well as functional computer skills.
• Familiarity and working knowledge of 110v single-phase circuitry to 480v three phase, as well as AC and DC servo drives.

• Start-up and trouble-shooting skills are required for all product lines.

• Able to read and interpret blueprints and electrical specifications as needed.

• Attention to Detail - Job requires being careful about detail and thorough in completing work tasks.
• Dependability - Job requires being reliable, responsible, and dependable, and fulfilling obligations.
• Cooperation - Job requires being pleasant with others on the job and displaying a goodnatured, cooperative attitude.
• Persistence - Job requires persistence in the face of obstacles.
• Initiative - Job requires a willingness to take on responsibilities and challenges.

• Minimum 4 years' experience in a production/electrical environment preferred.

• While performing the duties of this job, the employee is frequently required to stand, sit and walk. The employee regularly uses hands and fingers. The employee must also be capable of bending, reaching, kneeling, crouching, and climbing. The employee must regularly lift, push, pull, and/or move up to 25 pounds.
• While performing the job light to moderate physical activity, performing strenuous daily activities of a product/technical nature is required.
• While performing the job the employee may be exposed to various environmental conditions, loud noise levels and more frequently working around mechanical parts.
• To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed above are representative of the knowledge, skill, and/or ability, and physical demands required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.
• Up to 10% overnight travel.